Hi,

I have tested the basicgrayscale printing with Fuji DRYPIX 4000 printer but it was not sucessful. Actually I have entered some logging codes in between and taken the following result :

INFO  - Association Accepted from MYCLIENTAETITLE to remote AE DRYPIX4000:10.35.88.252:104
INFO  - Sending Create Film Session Request
INFO  - Sent Create Film Session Request
INFO  - Success status received in Printer Status Scu!
INFO  - Requested FilmBox
INFO  - Sending Create FilmBox Request
INFO  - Sent Create FilmBox Request
INFO  - Requested ImageBox
INFO  - Sending Image Box Request Session Request
INFO  - Sent Image Box Request Session Request
INFO  - Timeout Expired for remote host DRYPIX4000, aborting connection
WARN  - Completed aborting connection (after DIMSE timeout) from MYCLIENTAETITLE to DRYPIX4000

As can be seen from the logging info ImageBoxRequest times out. When I looked at the comformance statement of this device I see that BasicGrayScalePrinting is supoorted by the device.

Does anybody have an idea what is going on? When Iı try the conquest simulator. It sucessfully prints the images but when I try it with the DRYPIX 4000 printer it times out.

Hi, sorry I can't be of much help here. Do you have access to a Fuji service rep who can help you to diagnose the problem? Or, if you can successfully print to it from another device, try printing from that device to your simulator and compare what it sends with what you're sending by analyzing the DICOM command contents in both cases. I've had success with that approach in the past.

Hope this helps,
Stewart

Hi,  nck

i have the same error message and same problem with same printer Fuji DRYPIX 4000 by using same clearcanvas class BasicGrayscaleScu.

have you solved this issue. could you tell me the solution.

i shall be very thank full to you

 

I am also into the same problem when I send Print using BasicGreyScaleScu Class function, i get Timeout Expired for remote host .
I have also configures this Printer with eFilm Workstation and it is sending print out on there with same settings. what could possibally be wrong in my code?

hi,

i am on the same track and stuck at the same point. could you please guid me if you have solved this issue.

it would be really great help for me if you send me the source code that can print successfuly.

thanks in advance. waiting for your reply.

ilyasanjum@peridotec.com

Anjum